Omnimount TILT-PA - Manual (Page 5)

8
Step 4 — Rail Installation
Standard Configuration Narrow Configuration
Step 5 — Secure Sliders and Back Plate
1. Set Rails to horizontal distance between Mounting Holes on Display.
2. Loosely thread Slider Retaining Screws through Channels into Sliders
5
Step 1 — Set Studs in UM-1
1. Insert Stud Screws (4) into front of Adapter.
2. Thread Flange Nuts (4)
onto Stud Screws and tighten
using a 5/16” Socket. 3. Thread Nylock Nut (2) onto the
two top Stud Screws leaving space
between Nylock and Flange Nuts.
Insert Stud
Screws Here