Sylvania SRTD420 - Manual (Page 15)

– 15 – EN
0C28
DEGAUSSING
This television has a degaussing circuit that will clear
up color errors on the TV screen that are caused by
any excess magnetism which happens to get too
close to the TV. This circuit is designed to operate
once when the set is first plugged in. If minor color
errors are seen in some locations on the screen,
please unplug the TV for approximately 15 minutes.
When the TV is plugged back in, the degaussing cir-
cuit will operate once to clear them up. Repeat this
procedure any time the TV screen is accidentally
magnetized, or when the TV is moved or relocated.
WATCHING A TV PROGRAM
1
Turn on the TV/DVD
Press POWER to turn on the TV/DVD.
2 Select the channel number
Press CHANNEL(CH.) K/L to select your desired
channel number, or press the number buttons.
Notes for using the number buttons on the remote
control:
• You must proceed single-digit channel numbers
with a zero (Example: 02 ... 09).
• When selecting cable channels which are higher
than 99, press +100 first, then press the last two
digits. (Example: to select channel 125, first press
+100, then press 2 and 5).
Remember:
¡ If the TV/DVD is connected to a cable box or
satellite box, the TV/DVD must be on CH3 or
CH4, then the channel to be viewed must be select-
ed on the cable box or satellite box.
3 Adjust sound
Press VOLUME(VOL.) X X /Y Y to
adjust the volume.
NOTE:
• If you press CHANNEL(CH.) K/L in the DVD
mode, you can change the TV channels.
When you turn off the TV/DVD in the DVD mode,
when you turn it on again, it will return to the TV
mode.
TV
PICTURE CONTROL
The TV/DVD’s picture controls – BRIGHT, CON-
TRAST, COLOR, TINT and SHARPNESS – are
preset to factory specifications. Although they are
usually the best, you may need to make some further
adjustments for your individual preference.
Make sure ...
• TV/DVD power must be turned on.
1 Select “PICTURE CONTROL”
Press PICTURE on the remote control.
2 Select item you want to adjust
Press Arrow (K/L) until desired control is displayed.
BRIGHT
CONTRAST
COLOR
TINT
SHARPNESS
3 Adjust the picture control
Press Arrow ( s / B ) to adjust to your desired level
within 5 seconds.
NOTE:
• At step [3], the picture adjustment display will dis-
appear from the TV screen after about 5 seconds
unless you press any buttons, even though you may
not be finished. In this case, repeat from step [1].
TV
• If there is a power failure of any kind, the unit will
retain its memory of the setting you have selected.
VOLUME 20
C C C C C C C C C C C C C C C C
BRIGHT
– P P P P P P P P P P P P P P C C P P P P P P P P P P P P P P +
TV OPERATION
to decrease
brightness
to decrease
contrast
to pale to brilliant
to green
to clear
to purple
to soft
to increase
brightness
to increase
contrast
BRIGHT
CONTRAST
COLOR
TINT
SHAPNESS
Arrow Button { Arrow Button B
T9005UF(EN).QX3 04.4.12 10:06 AM Page 15