Olympus DS-5000 - Manual (Page 46)

46
3
Device Lock Function
Unlocking the Recorder
When the password registry and/or fingerprint
registry is done, the recorder will prompt for
password and/or fingerprint verifications (DS-
5000iD only) on startup.
Unlock the recorder’s device lock through the
method below.
The default password when using the recorder
for the first time is “0000”.
Recorder access can be restricted by enabling the
device lock function. Authentication via password
and/or fingerprint verification (DS-5000iD only) can
act as a safe guard for your data even in case the
recorder is lost or left unattended.
Fingerprint registry (
☞ P.47) is performed by
the recorder, while password registry can be
performed by using DSS Player (
☞ P.69).
DS-5000iD DS-5000
Unlocking the Recorder with a
Password
1 Select the numbers you want to enter
by pressing the
+
,
–
, 9 or 0 button
to move the cursor.
2 Press the OK/MENU button to select a
number.
A * will appear in the selected first digit and the
blinking cursor will move to the next one over (to
the right). Repeat steps 1 and 2 to enter all four
digits.
Pressing the ERASE button at any time will erase
the last entry and move the cursor to the previous
entry (to the left).
3 After all four digits have been entered,
press the
F2(ENTER) button.
If the 4 digit number entered matches the
registered password then the startup message
will appear and the recorder will start up.
Entry column
Cursor
Device Lock Function
Unlock Device
Enter Password
Unlock Device
Enter Password
or Sweep Finger
Unlock Device
Enter Password
or Sweep Finger
Unlock Device
Enter Password
or Sweep Finger
Unlock Device
Enter Password
ENTER
or Sweep Finger
F2 button
OK/MENU,
+
,
–
,
9, 0
button