Olympus DS-5000 - Manual (Page 47)

47
3
Device Lock Function
Press your
finger firmly at
the fingerprint
sensor, and slide
it at a constant
speed.
Unlocking the Recorder Via Fingerprint
Verification (Only DS-5000iD)
Slide the finger to be scanned for
verification over the scanner window on the
back side of the recorder in one sweeping
motion from top down as shown in the
illustration.
If [NG! Sweep Finger Again] is displayed, re-scan
your finger or a different registered finger again. If
there is no fingerprint match after 10 tries [Incorrect
Fingerprint Enter Password] will be displayed and it
is not possible to authenticate via fingerprint
verification.
Device Lock Function
In case the fingerprint may not be scanned correctly,
press your finger firmly against the sensor and sweep it.
How to Scan the Fingerprint
• Place your finger as shown in the diagram
and start scanning from a state where the
first joint of your finger is touched to the
fingerprint sensor.
• Pressing the finger securely, and slide from
the first joint of your finger to fingertip properly
on the sensor in direction of the arrow
approximately 1 second at a constant speed.
• Slide straight the finger to the center of the
fingerprint sensor without winding.
• While sliding, do not move the finger away
from the sensor.
Notes
The register and verification of the fingerprint may
have difficulties in below cases.
• The state of finger is as follows:
➥Using the other registered finger or after washing the
hand, it may improve.
- When the finger is dry.
- When the finger got swollen such as just after taking a bath.
- When the finger is either sweaty and greasy or wet.
- When the finger has a rough skin or is injured..
- When the finger is dirty.
- When the fingerprint is light and wrinkly.
• When the direct sunlight or strong light gets to the
fingerprint sensor.
• When the fingerprint sensor is dirty.
➥Wipe off with a soft cloth etc.