Oregon Scientific RM622PA - Manual (Page 5)

5
EN
ACTIVATING / DEACTIVATING THE RF SIGNAL
1. To activate the RF signal, press and hold for 2
seconds.
2. To deactivate the RF clock reception, press and hold
ZONE for 2 seconds.
NOTE The RF signal icon appears on the LCD when
it is activated and disappears when it is deactivated. If
the clock cannot recive any signal reception, appears
instead of . See section on "Troubleshooting" for more
information.
SETTING THE CLOCK MANUALLY
The 12-hour clock automatically sets itself to the U.S.
Atomic Clock - it never needs adjusting for Daylight
Saving Time. The top line of the clock display shows
hours, minutes and seconds / day-of-the-week. To toggle
between seconds and day-of-the-week display, press
MODE. The second line shows calendar (month and
date) / alarm time and indoor temperature.
To adjust the clock settings manually without automatic
RF synchronization, remember to deactivate the radio
reception first.
Each of clock settings can be adjusted in the following
order: hour, minute, year, month, date, and language (E,
S, F).
1. Press and hold MODE for 2 seconds. The first
clock setting, the hour setting, begins flashing.
2. Press or to adjust the hour values. To choose
the values more quickly, press and hold or
continuously.
3. To confirm and save the desired hour value, press
MODE. The next clock setting, the minute setting,
automatically begins flashing.
4. Repeat steps 2 and 3 to adjust the clock minute
values and the other clock settings accordingly.
5. After adjusting the hour and minute, you may decide
to skip adjusting the minute, year and month, and go
directly to adjust the date settings. To skip any
setting, press MODE to navigate through the items
until you reach the desired setting.
NOTE When adjusting the date on the second line of the
LCD, the corresponding day-of-the-week shown on the
LCD’s top line will change automatically.
NOTE The time is shown only in 12 hr AM/PM format. 24
hr format is not available in this unit.
NOTE During anytime you are in the middle of adjusting
a clock setting manually and is left idle for 1 minute, the
clock automatically saves the current setting chosen.