Troubleshooting – Oce North America OP14 User Manual

Page 14

Advertising
background image

7

3. Troubleshooting

Error code

E60

E70

E71

E72

E73

E80

E82

E83

EF1

EF2

Procedure

A read- or write-error has occurred on the RAM disk. Press the Start [GO] key to erase the error indication.

A read- or write-error has occurred in the Memory Card. Press the Start [GO] key to erase the error indication.

The Memory Card was removed during operation under the menu for printer-related settings. Reinsert the Memory Card.

* BE SURE to turn the main switch OFF (O) BEFORE inserting the Memory Card.

The Memory Card could not be detected during an operation in which the printer was reading data from that card. Reinsert

the Memory Card.

* BE SURE to turn the main switch OFF (O) BEFORE inserting the Memory Card.

Initialization of the Memory Card currently inserted is necessary.

A data overrun error has occurred due to insufficient memory.

• If you want to force-continue the print job, press the Start [GO] key. If you want to cancel the printing operation completely,

press the Stop/Reset key.

• If “Auto Continue” (menu: P74) is turned “On” (setting: 1), the printing operation will be restarted automatically after the

amount of time specified there.

• Once this error message is displayed, “Page Protect” (menu: P42) will be turned “On” (setting: 1) automatically.

The current print job could not be completed due to insufficient memory in the printer.

• If you are using a RAM disk, reduce the size of the RAM disk. If this error occurs often, it is recommended that you install

additional memory into the printer. For more detailed information on adding memory, contact your service representative or

an authorized service center.

• If you want to force-continue the print job, press the Start [GO] key. The data that has already been processed will be printed

out and the remaining portion of the print job will be printed onto the following page.

• If “Auto Continue” (menu: P74) is turned “On” (setting: 1), the printing operation will be restarted automatically after the

amount of time specified there.

The selected interface is currently in use. Wait for a while and then attempt the operation again.

An error has been detected during operation. Turn the main switch to the printer OFF (O) and then back ON ( | ) again. If the

same error message remains, contact your service representative or an authorized service center.

An error has been detected during operation. Turn the main switch to the printer OFF (O) and then back ON ( | ) again. If the

same error message remains, contact your service representative or an authorized service center.

Advertising