Oki 520 - Manual (Page 37)

E-30 Section 3
Form Tear-Off. Choose 500ms, 1 sec, or 2 sec to turn
this feature on and select a time interval for the printer to
wait before advancing the paper.
Gap Control. Determines how the printhead gap is set.
Auto Gap automatically determines paper thickness on
first page: for single sheets, it also rechecks each page
while printing. Semi Auto Gap is similar; but it does not
recheck single sheets while printing. You can also choose
a fixed headgap setting of 1 (narrowest) to 9 (widest).
Graphics. Change to bi-directional graphics for faster
printing: optimize by the Print Registration setting in the
Menu.
I-Prime. Sets what the printer does when it receives the I-
Prime signal from software. Buffer Print (factory default):
prints out buffer contents before resetting. Buffer Clear:
dumps buffer contents immediately. Invalid: ignores I-
Prime signal.
Language Set. Replaces certain symbols with special
characters used in the respective foreign language.
Line Spacing. Change from 6 to 8 lpi (lines per inch) to
get more lines per page.
Operator Panel Function. Change to Limited Operation to
deactivate PRINT QUALITY and CHARACTER PITCH
buttons when several people are using the printer and you
don’t want these settings changed from the control panel.
" This feature also prevents normal access to the
Menu. To access the Menu, turn the printer off, then
hold down the SEL key while turning the printer on.
Page Length. Selects the length of the paper you’re using.
Page Width (Model 521 only). Choose 8” for letter-size
paper.
Paper Out Override. Senses when less than one inch of
paper remains and stops printing. Choose Yes to override
the detector. Caution!! This can cause loss of data and
damage the printhead.
Pin 18. Sets the signal on pin 18 to +5V (factory default)
or Open.
Pitch. Choose character width measured in characters per
inch (cpi).
Print DEL Code (MICROLINE Standard). Change to
Yes if you wish to print the DEL code (decimal 127) as a
solid box.
Print Mode. Choose NLQ Courier or NLQ Gothic font for
letter quality printing, utility (factory default) for faster draft
printing, or HSD for fastest printing (lowest quality).