Oki 520 - Manual (Page 68)

With Forms Tear-Off Set to ON
SEL
SEL
POWER
LF FF/LOAD TEAR PARK QUIET
SHIFT Micro Feed
Down
TOF Micro Feed
Up
EXIT GROUP SET PRINT ITEM
ALARM MENU
MENU
First: Check/Set the Tear Position
1. Turn the printer ON and press PARK to remove the
paper from the path.
The alarm light comes on.
2. Press SHIFT and QUIET/TOF to reset the Top of Form.
3. Press FF/LOAD to pull the paper back in.
The Alarm light goes out.
4. Press SELECT to take the printer off-line.
The SEL light goes out.
5. Wait until the paper moves up to the Tear position.
6. To change the tear-off position: press and hold SHIFT,
then press LF/Micro Feed Up to move the tear-off
position down or FF/LOAD/Micro Feed Down to move
the tear-off position up.
Next, Set the Top of Form Position
1. Press SHIFT and TEAR.
The paper goes to the current TOF position.
2. Continue holding SHIFT and release TEAR.
3. Continue holding SHIFT, then press LF/Micro Feed Up
to move the TOF location down on the page or FF/
LOAD/Micro Feed Down to move the TOF location up.
! The first line of printing is indicated by the red line ( 1)
on the printhead’s plastic shield.
4. Keep holding the SHIFT button and press the
QUIET/TOF button a few times to engage the new
setting.
5. Press SELECT to place the printer back on line.
1