Olympus LS-7 - Manual (Page 30)

2
30
EN
R
e
cording
d
a
b
c
e
About recording
Recording
1 Select the recording folder
(
☞ P.27).
2 Press the REC (
s) button to
prepare recording.
• The recording indicator light will flash
and [
≠] will appear on the display.
• Turn the microphone in the direction
of the source to be recorded.
• This recorder is designed to be able
to record cleanly and evenly, even in
recording conditions such as when
the volume of the source sound
changes significantly. However, even
higher sound quality recordings
can be achieved by adjusting the
recording level manually (
☞ P.51).
3 Press the REC (
s) button to start
recording.
• The recording indicator light grows
and [
K] will appear on the display.
e Elapsed recording time
• [Rec Mode] cannot be changed in
the recording standby mode or while
recording. Configure this while the
recorder is stopped (
☞ P.51).
• Placing the built-in stereo
microphone over the display is the
proper position for performing stereo
recording. If it is below the display
when recording then proper stereo
recording cannot be performed
because the position of the original
sound will be recorded in reverse
phase.
Before starting recording, select a folder
among [
&] to [*]. These five folders can be
selectively used to distinguish the kind of
recording; for example, Folder [
&] might
be used to store private information, while
Folder [
'] might be dedicated to holding
business information.
STOP (
4) button
REC (
s) button
a Recording mode
b Remaining recording time
c Remaining memory bar indicator
d Level meter (changes according to
the recording level and recording
function settings)