The Singing Machine STVG-999 - Manual (Page 20)

CD OR CD+G OPERATION
PLAY/PAUSE MODE
STOP MODE
SKIP PLAY (For both CD and CDG discs.)
SEARCH (For audio CD disc only.)
REPEAT
PROGRAM
!
!
!
!
!
!
!
!
!
To start playing, press the PLAY/PAUSE button. The first track [ ] and the PLAY/PAUSE
LED will be lit.
To temporarily stop playing, press the PLAY/PAUSE button. The PLAY/PAUSE LED
Indicator will flash.
To resume play, press this button again.
If the STOP button is pressed in the course of playing, the disc it will cease to play. (The total
number of tracks will be shown on the LED display).
During STOP mode, you can skip up or down to your desired track number by pressing a
SKIP button(
- SKIP - ).
To resume playing the selected song, press PLAY/PAUSE button.
When playing any audio CD, press and hold the SKIP button ( -SKIP- ). The CD will
search at high speed in the forward or backward direction. Normal play will continue when you
release the button.
To repeat the track currently playing, press the REPEAT button once. The REPEAT LED will
start to flash.
To repeat all tracks, press the REPEAT button twice. The REPEAT LED will remain
illuminated.
To clear the repeat function. Press the REPEAT button again. The REPEAT LED will no
longer illuminate.
PLEASE NOTE: Pressing pause when a CDG is playing may cause distorted lyrics on the
monitor. Any distortion will remain until the whole screen is refreshed during
an instrumental break or you stop the song and start it from the beginning.
Use this button to program and play back songs in a preselected order.
Step 1: Programming should be done in the stop mode only. Press the PROGRAM key
until the PROGRAM LED flashes, the track will read [ ].
Step 2: Press the double arrow keys ( -SKIP- ) to select a desired track.
Step 3: Press PROGRAM key to confirm entry. You can repeat the same steps up to a
maximum of 20 tracks.
Step 4: Press PLAY to activate PROGRAM.
Press the STOP button to clear all the programmed entries.
Pressing the KEY HIGH/ KEY LOW button will allow different ranges to be adjusted as shown
on LED.
KEY FLAT button is used to adjust the key level back to default level.
KEY HIGH is used to raise the key level.
KEY LOW is used to lower the key level.
!
!
!
!
!
KEY CONTROL
E19
ENGLISH