Toshiba ESTUDIO 3511 - Manual (Page 313)

Printing Guide — Printing from UNIX 313
— Paper Source
The paper source can be selected using the following options.
In PostScript Deferred Media Selection is always turned on so the paper size has priority over
the paper source. In PCL5e the paper size always has priority over the paper source.
If this option is not specified the command will not be sent so the printer’s default value will be
used.
Example: The command to specify the LCF paper source is “lp – o lcf filename”.
— Duplexing
The current duplex mode can be specified using the following options.
NOTE: • 2-sided printing is available only when the ADU is installed.
If this option is not specified, the default value “simplex” will be used.
It is not necessary to specify duplexing for Booklet Mode (sduplex). Setting duplexing sepa-
rately can override the booklet mode setting for duplexing.
Example: The command to specify long edge duplexing is “lp –o duplex filename”.
— Paper Sizes
The current paper size can be specified using the following options.
Option Value Alternate
Value
Description
auto-source Select auto paper tray selection.
manual Select stack feed bypass.
upper cas1 Select the upper drawer.
lower cas2 Select the lower drawer.
lcf LCF Select the large capacity feeder.
pedupper cas3 Select the upper pedestal drawer.
pedlower cas4 Select the lower pedestal drawer.
Option Value Alternate
Value
Description
simplex Turn duplexing off.
duplex lduplex
duplex_long
duplex=long
hduplex Turn duplexing on with long edge binding.
sduplex duplex_short
duplex=short
vduplex Turn duplexing on with short edge binding.
Option Value Alternate
Value
Description
letter lt
LT Select letter size paper.
A4 a4 Select A4 size paper.