Tunturi E 2 - Manual (Page 5)

8 :: :: 9
MAIN DISPLAY ::
When you turn the user interface on, the display shows the following
exercise parameters:
1. Effi ciency (W)
:: Figure indicates exercise effi ciency in Watts, which depends on
pedalling speed and resistance adjustment.
2. Energy consumption (kcal/kJ)
:: Displays cumulative energy consumption (0-999); default setting
is kcal.
3. Speed (rpm / km/h / mph)
:: Default setting is rpm (pedal revolutions / minute).
4. Pulse
:: Heart rate transmitter belt or an ear sensor is required.
:: If the user interface does not receive a heart-rate signal, - - is
displayed instead of the heart rate.
NOTE! Always disconnect the ear sensor from the user interface if using
a heart rate transmitter belt; the ear sensor will interfere with the heart
rate transmitter.
5. Time
:: Displays the exercise time elapsed between 0:00 - 59:59 minutes
and between 1:00 - 10:00 hours in 1 minute increments.
:: Time display stops if speed falls to zero.
6. Distance (km / miles)
:: Default display setting is km.
:: Displays the distance travelled during the workout in km (or
miles) to two decimal points up to 9.99 km (or miles) and with
one decimal point up to 99.9.
METER ::
RESET
Pressing Reset always resets the value on the display.
SET
Press Set key for 2 seconds to set units of measurement.
:: Default units are rpm, km and kcal.
:: To change the units press the - or + key until the desired units are
displayed.
:: To measure speed you can set either revolutions per minute,
(rpm), kilometres per hour (km/h) or miles per hour (mph).
Energy consumption measurement can be set for kilocalories
(kcal) or kilojoules (kJ).
:: In addition to rpm you can also select either kilometres (km) or
miles as distance measures. If km/h is selected as the unit to
measure speed, km will automatically be the unit for distance. The
same applies to the units mph and miles.
:: The user interface automatically returns to the main display 5
seconds after the Set key was last pressed.
:: Press the Reset key to exit the setting function without saving the
adjustment. This resets the readings on the main display.