Instruction manual for the technisat vc 2002 s, Safety instructions, Technisat – TechniSat VC 2002 S User Manual

Page 2: Vc 2002 s

Advertising
background image

TechniSat

®

VC 2002 S

2

INSTALLATION:

The procedures set out on page 5 should be fol-
lowed carefully.

NOTE:
Always connect the LNB before connecting to
the mains supply. Failure to do this may cause
damage to the appliance.

Ventilation:
Vents on the top and side panels are provided
for necessary ventilation. The appliance should
not be placed in a position where the free pas-
sage of air would be severely restricted. In addi-
tion, for the same reasons as above, the VC
2002 S should not be placed on a soft base.

Water and moisture:
Ensure that the appliance does not come into
contact with any dampness or moisture - RISK
OF ELECTRIC SHOCK (and/or damage to the
VC 2002 S).

Heat:
Do not install the VC 2002 S in the immediate
proximity of a heat source (radiator, oven etc.).

CARE AND USE:

Power source:
Connect the VC 2002 S to a power supply which
matches the requirements of the appliance (240
V/50 Hz).

Safe connection to the mains:
The mains leads should be routed so that they
are not likely to be walked on or pinched by items
placed against them.

When not in use:
If the VC 2002 S is left unattended or unused
for long periods of time be sure to unplug the
mains connector.

Unplug the VC 2002 S from the mains when:
-

the mains lead or mains connector is
damaged

-

the VC 2002 S has been exposed to rain
or water

-

a solid object or liquid substance has
entered the appliance via the air vents

-

there is a noticeable change in the
performance of the VC 2002 S, the
appliance is not operating as normal

-

the VC 2002 S has been dropped or the
outer casing has been damaged

NOTE:
Servicing and repairs must only be carried out
by trained service staff.

Accessories and replacement parts:
Both accessories and replacement parts should
only be purchased as recommended by your
satellite dealer. Be sure to consult your dealer
in all aspects concerning equipment purchase,
servicing and repairs.

Cleaning:
Disconnect the VC 2002 S from the mains befo-
re cleaning. Use a damp cloth only. Do not use
liquid or aerosol cleaners.

.

INSTRUCTION MANUAL FOR THE TECHNISAT VC 2002 S

SAFETY INSTRUCTIONS

I

n the interests of safety please read and observe the following instructions

before using your new VC 2002 S. This sheet and the following pages

concerning installation and operation should be retained for future reference.

Advertising