TechniSat VC 2002 S - Manual (Page 8)

TechniSat ® VC 2002 S
Watching a scrambled Videocrypt programme
1. Select a coded channel (eg. Movie Channel
or Sky Movies Plus).
2. Insert the viewing card as indicated by the
arrow.
3. After a few seconds the descrambled
picture will appear on the screen.
NOTE: Do not bend or damage the card in any way.
SCREEN MESSAGES:
“Please insert card” - make sure that the card
is inserted correctly.
“Please wait” - descrambled picture should
appear in a few seconds.
“Your card is invalid” - ensure the card is ins-
erted correctly and/or has not been damaged.
“Your card has expired” - a replacement card
is required.
“Channel blocked” - indicates there is some-
thing wrong with your card.
In the case of the last 3 messages, first of all try
turning the receiver off, disconnect from the
mains and leave for one minute. Turn on again
and retry card. If this still fails contact BSkyB.
8
PROGRAMMING
CONNECTING A SEPARATE DECODER: (*)
To choose between normal and decoder mode
press DECODER:
In position “n” the reception signal will be connec-
ted directly from the TV or video recorder.
In position “d” the coded signal (non-Videocrypt
coded channels) is sent from the scart socket
to the decoder. The decoded signal is sent back
to the receiver and can be picked up at the scart
socket or at the UHF output connection.
Press the D MODE button to select the deco-
der signal according to the following table:
D1: Flat, MAC compatible signal
D2: PAL de-emphasised baseband signal
D3: Unclamped video signal
D4: Clamped video signal
Be sure to consider the recommendation of the
manufacturer regarding the connection of the
decoder.
(*)DOES NOT APPLY TO VIDEOCRYPT INTER-
NAL DECODER, BUT REFERS TO THE USE
OF A SEPARATE DECODER FOR NON-
VIDEOCRYPT CODED CHANNELS.
FREQUENCY SHIFT:
If the LNB of the outdoor unit does not supply
the exact IF-frequency, it is possible to change
it as follows:
1. Press the “V/H” button for about 3
seconds.
2. The receiver displays “AFC”.
3. Enter “999”.
4. The receiver displays “0.0”.
5. Now it can be tuned up or down (+/- 5 MHz)
with the tuning buttons.
6. Once you have achieved the best picture
quality you can store the frequency shift
with the STORE button.
NOTE: The frequency shift applies for all channels.