Tektronix Phaser 600 - Manual (Page 49)

C O N N E C T I N G T H E P R I N T E R
3 3
Turning on the printer
C A U T I O N
Before turning on the power to the printer, make sure that you have removed all
shipping material from inside the printer; otherwise, you can damage the printer.
See
Removing the transit restraint , Removing the shipping blocks , and Removing adhesive
tape and cable tie .
❏
Transit restraint: (printhead) inside the printer’s top cover.
❏
Cable ties: inside the printer’s top cover.
❏
Shipping blocks: (fuser) inside the exit cover.
Make sure that you have attached the ink loader to the printer and that its cover is
closed; otherwise, the printer will not start up.
C A U T I O N
To protect your printer from a power surge, make sure that the power switch on the
printer is in the
off position before plugging in the cord. You can also use a surge
protector that is designed for computer equipment.
Make sure that you use the power cord that is shipped with the printer. If you need a new
power cord, contact your local Tektronix dealer.