Topcom COCOON 50 - Manual (Page 30)

8.12. MEMORY NUMBERS
The Cocoon disposes of 10 memory numbers (speed dial numbers). Each
memory place can store a telephone number of maximum 22 digits. You can call
a memory number by pressing the memory button
followed by the
number of the memory place (0-9) where the desired telephone number has
been stored.
8.12.1. STORING MEMORY NUMBERS
• Press the set button .
• Press the memory button
• The LCD display will show “[ ]“ (LCD version only)
• Choose a memory place by pressing a numerical button (0-9).
• The LCD display will show the selected memory location.
(LCD version only)
• Enter the telephone number that you wish to store.
• Press the set button
.
You can also program a pause in the memory numbers. During the
programming of the memory numbers press the redial button
for a 3
seconds pause (For the LCD version, ‘P’ appears on the display).
8.12.2. DIALLING A MEMORY NUMBER
• Press the line button and wait for the dial tone.
• Press the memory button
• Press the number of the memory place, where the telephone number has
been stored (0-9). The telephone number is now automatically dialled.
8.12.3. MEMORY NUMBER PREVIEW (LCD VERSION ONLY)
• Press the memory button in standby mode.
• The LCD display will show “[ ]“.
• Press the memory location number (0-9).
• The corresponding telephone number will be displayed for 5 seconds, then
the phone returns to standby mode.
If the memory location is empty, a fail tone will be generated.
8.12.4. ERASING A MEMORY NUMBER
• Press the set button .
• Press the memory button .
• The LCD display will show “[ ]“ (LCD version only).
• Press the memory location number (0-9).
• Press the set button again
.
8.13. KEY TONE ON/OFF
The key tone setting can be programmed as follows:
• Press the set button again
.
• Press <4>.
• The LCD display will show the current setting of the key tone ON/OFF (LCD
version only).
• Press <1> for key tone ON, <2> for key tone OFF
• The LCD display will show the change (LCD version only).
• Press the set button again
to confirm entry.
8.14. 15 MINUTES CONVERSATION TIMER
To avoid that you would forget to end a conversation or that you accidentally
press the line button without having a conversation there is a 15 minutes time
limitation after pressing the line button.
Therefore, during your conversation, the telephone will generate a warning beep
after 14 minutes and 30 seconds.
To continue your conversation and to avoid the connection from being broken
automatically, press a numerical button (0-9). If no key is pressed when the
timer runs to 15 minutes, the line will be disconnected automatically.
10 11
50 50