Telstrat 7300A - Manual (Page 30)

58 59
Record your own outgoing message
To record a new Answer Only message you must fi rst set up your answering machine to Answer Only, see page 58. Similarly,
to record a new Answer & Record message the answering machine must be set to Answer & Record.
An Answer & Record message can be up to 2 minutes long. An Answer Only message can be any length
depending on the amount of recording memory available.
1. Press 8PY` scroll to Ans. Machine menu and press 8PY`
2. Scroll .LWW^ or to Ans. Settings and press 8PY`
3. **Listen** will be displayed and you will be prompted to enter to hear the menu options
4. Press BCDE
$
to start to record your new message. Press

to end recording and your new message
will be played back to you.
5. Press and hold 8`_P to return to standby.
Play outgoing message
If the answering machine is set to Answer Only you will hear the Answer Only message. Similarly if
Answer & Record is on you will hear the Answer & Record message.
1. Press 8PY` scroll to Ans. Machine menu and press 8PY`
2. Scroll .LWW^ or to Ans. Settings and press 8PY`
3. **Listen** will be displayed and you will be prompted to enter to hear the menu options
4. Press ?@A
#
to hear your message.
5. Press 8`_P to return to standby.
Using the answering machine (7300a only)
Switch on/off
1. Press 8PY` to scroll to Ans. Machine menu and press 8PY` .
2. Scroll .LWW^ or to Ans. Settings and press 8PY`
3. **Listen** will be displayed and you will be prompted to enter to hear the menu options
4. Press

to select On or Off. The voice prompt will announce “Answer on” or “Answer off” as
appropriate.
5. Press and hold 8`_P to return to standby.
Outgoing messages
This is the message your callers hear when the answering machine picks up their call. Your Telstra
7300a comes with two pre-recorded outgoing messages to choose from.
To set your answering machine to Answer & Record or Answer Only, see Set answer mode, Page 60.
Answer & Record
This invites your caller to leave a message.
The pre-recorded message is, “Hello, your call cannot be taken at the moment, so please leave your
message after the tone”.
Answer Only
This does not allow your caller to leave a message.
The pre-recorded message is, “Hello, your call cannot be taken at the moment, and you cannot leave a
message, so please call later”.
Using the answering machine (7300a only)