TOA Electronics OVATION U720 - Manual (Page 59)

Section 2C: Menu Options 53
Sprint Connection Manager Settings
To customize your Sprint Mobile Broadband - Novatel Wireless
settings, select Menu > Settings > Sprint (connection name), and then
select from the following menu options:
ⅷ Always Show Welcome Screen – Select this check box if you
would like to have a welcome screen appear upon a successful
connection to the network.
ⅷ Perform Pre-Connect Tests – Select this check box if you would
like to see what may have caused a failure if Sprint Connection
Manager was unable to connect.
ⅷ Enable Network Adapter (NDIS) – Allows you to establish a
Novatel Wireless (1xEV-DO) connection to connect to the
network automatically without launching Sprint Connection
Manager. You can disable the Enable Network Adapter mode
at any time by deselecting the Enable Network Adapter (NDIS)
check box from this menu. (See below for more information
about enabling NDIS.)
Novatel Wireless Network Adapter (NDIS)
Enabling the Novatel Wireless Network Adapter enables always-on
connectivity like an Ethernet card and eliminates the need to use the
Sprint Connection Manager software. As soon as the USB connector is
inserted into your USB port, the device connects to the network
automatically. The connection is also reestablished automatically
coming out of hibernate and standby modes.
To enable the Novatel Wireless Network Adapter:
1. Disconnect the Sprint Mobile Broadband USB modem from
the Sprint network. (If you are connected to the network, the
Enable Network Adapter [NDIS] check box will be disabled.)