Technics SX-PR54/M - Manual (Page 134)

135
QQTG0701
Assembly
Follow the steps below to assemble your Technics piano. Make sure you are using the correct parts and
that they are in the correct direction.
• At least 2 people are required for assembly.
• To disassemble the piano, reverse the procedure.
1. Remove the packing and take the parts out of
the carton. Confirm that all the parts on the
printed list are present.
2. The following parts are in the screw kit.
3. Affix the right and left side planks to the pedal
box.
(1) Use the 4 brass-colored screws to secure the planks.
(2) Loosen the pedal cord, stowed on the inner side of the
pedal box, and extend it.
4. Affix the rear panel.
• Use 2 black screws (C) and 4 black screws (B) to affix the
rear panel.
5. Place the piano
body on the stand.
WARNING:
Avoid pinching your fin-
gers.
Note 1
Holding the piano body at
least 10 cm in from the
edge, place it on the
stand so that it does not
fall off.
Note 2
If the piano body is placed too far to the right or left, or to
the front or back, it will become unstable.
6. Secure the piano body to the stand.
(1) Insert 2 screws in the 2 rear screw holes on the under-
side of the piano body, and turn each screw 5 or 6 times.
Push the piano body forward so that the screws are fully
inserted in the cutout of the metal piece on either side
plank. (This enables you to easily position the piano body
on the stand.)
(2) Adjust the piano body so that the right and left sides
project evenly over the stand.
(3) Positioning the piano body on the stand, confirm that the
4 screws can easily be inserted.
(4) Tighten the 4 screws securely.
7. Connect the pedal cord and power cord to the
terminals.
(1) Plug the pedal cord and power cord into the terminals on
the rear of the piano.
(2) Remove the backing from the clamps and affix them as
shown in the figure. Secure the pedal cord to the clamps.
Confirm: After assembling, check these points.
•
Are any parts left over?
→ Check the assembly procedure again.
• Does the piano rattle when it is rocked?
→ Make sure all the screws are securely tightened.
• Is the power cord firmly inserted?
→ Check again.
• Is the plug of the pedal cord inserted as far into the con-
nector terminal as it will go?
→ If it is not completely inserted, the sustain and other
pedal functions may not work.
■ When the piano has been moved or transported,
retighten the screws securely.
List
Brass-colored screw............4
Black screw (A) ...................4
Black screw (B) ...................4
Black screw (C) ...................2
Pedal cord
(C)
(B)
Black
Screw (A)
PEDAL IN
plug
mark
With the mark
upwards, insert
the plug fully.
17_Initialize.fm 135 ページ ２００３年５月１９日 月曜日 午前１１時３７分