TP-Link TD-W8920G - Manual (Page 29)

TD-W8920G 108M Wireless ADSL2+ Router User Guide
22
Figure 4-6
1) Select the Connection Type and Encapsulation Mode your ISP has instructed you to
use, the default connection type is Bridging.
2) If you want to add to an assigned VLAN, please select the Enable 802.1q check box,
and enter the VLAN ID.
3) Click the Next button to go to the next screen to make further configurations for the WAN
Port, or else click the Back button to go to the previous screen to make modifications.
)
Note:
802.1q VLAN tagging is only available for the connection type of PPPoE, MER and Bridging.
After you select the Connection Type, please follow the instructions below to complete the
further configuration of WAN Interface. There are five different configurations for the connection
types, which are PPPoA, PPPoE, MER, IPoA and Bridge. You can select the corresponding
types according to your needs. Note that this User Guide adopts different VPI, VCI and QoS to
introduce further configuration for the different connection types below, if you need to change the
configuration of ATM PVC (VPI, VCI and QoS), you should go to the previous screen (shown in
Figure 4-5) to configure them again.
1. PPPoA
If you choose connection type PPPoA on the screen above (shown in Figure 4-6), you will
see the screen below (shown in Figure 4-7). Follow the instructions to configure the WAN
Interface.