True Manufacturing Company Swing Glass Door Merchandiser Refrigerator GDM-26 - Manual (Page 7)

2001 East Terra Lane • O'Fallon, MO. 63366 • ph. 636.240.2400 • toll free 800. 325.6152 • [email protected]
GDM SERIES COOLER EQUIPPED WITH EMS (ELSTAT) CONTROL
FREQUENTLY ASKED QUESTIONS
HOW?
• Push the set button key (looks like a snow flake) the screen should show PAS
• You will now need to enter the key dance
• Press the snow flake key 3 beeps
• Press the up arrow key 2 beeps
• Press the down arrow key1 beep
• Press the water drops key4 beeps (should show display of "PS")
• Press and hold the down arrow key until you view HR
• Press the snow flake key (display should show PAS)
• Re enter key dance and the Half Reset is complete.
How do I perform a Half reset, and what is it? Half reset clears any of the learning memory.
WHAT?
How do I put controller into Perishable mode?
• Perishable mode is used when anything perishable is being stored in the cabinet.
• In perishable mode, cabinet will maintain a 36°F-38°F product temperature. The
cabinet will not go into standby mode.
HOW?
• Press the set button key (looks like a snow flake): the screen should show PAS
• You will now need to enter the key dance:
• Press the snow flake key 3 beeps
• Press the up arrow key 2 beeps
• Press the down arrow key1 beep
• Press the water drops key 4 beeps (should show display of "PS")
• Now press and hold down the snow flake key until the screen shows PEr and 00.
• Next press and hold the up arrow key until the screen shows PEr and 01.
• Wait until controller reads "USE"; unplug the cabinet and plug it back in. At this
point the red LED in center of the control should be “on” which means that the
control is in perishable mode.
Can the Elstat come out of the "Stand by" mode before its predetermined time?
No. If the motion sensor is set off during the "Stand by" mode the control will automatically
turn the lights on, however it will stay in stand by mode.
Can the Elstat be set up for continuous use and not go into the "Stand by" mode?
Yes. The control can be set into perishable mode. This would shut down the "stand by"
mode. The lights will still cycle (like stand by mode) when cabinet doesn't see activity.
NOTE: There is no ability to set lights on all the time.
Can lights be set to stay on at all times?
No. Elstat controller does not have this capability. Lights will always turn off in "stand by"
Mode.
NOTE: All Energy Star cabinets are shipped in perishable mode
7