Toshiba PCS-1 - Manual (Page 126)

126
Connection Example With a Whiteboard
PCS -1/1P
3-207-456-12 (1)
I:\3207456121PCS1WW\07-2WB.FM masterpage:Left
Connection Example With a Whiteboard
• Be sure to turn off all the equipment before making any connections.
• Do not connect/disconnect the cable with the power on. Doing so may damage the
Camera Unit, Communication Terminal or mimio Xi.
Notes on using the mimio Xi
• Do not use any cable other than the dedicated cable supplied with the
recorder.
• Attach the capture bar vertically at the left upper corner of the whiteboard.
• The available area captured by the capture bar is limited to within 1300 × 900
mm based on the top left corner of the whiteboard. Anything written on the
whiteboard outside the area cannot be captured.
• Use only the stylus, marker and eraser that come with the mimio Xi for
writing on a whiteboard.
• Do not connect a device other than the mimio Xi to the WHITE BOARD
connector on the Communication Terminal.
Notes
DC 19.5V
AUDIO OUT AUDIO IN AUX1– VIDEO IN –AUX2 CAMERA UNIT MIC (PLUG IN POWER)
(MIXED)
AUX MAIN– MONITOR– SUB
VIDEO OUT
RGB OUT
IR OUT
100BASE-TX 10BASE-T
1 2
1 2 ISDN UNIT WHITE BOARD
DSB
TERMINAL VISCA OUT
Whiteboard
mimio Xi capture bar
to WHITE BOARD
Dedicated cable
(supplied with the mimio Xi)