Toshiba PCS-1 - Manual (Page 42)

42
Registering Local Information
PCS -1/1P
3-207-456-12 (1)
I:\3207456121PCS1WW\04SET.FM masterpage:Left
LAN Bandwidth
Selects the bandwidth to be used when
connected to a LAN.
You can select from among 384 Kbps, 768
Kbps, 1024 Kbps, 1920 Kbps and “Other”.
When “Other” is selected, a bandwidth value
between 1 and 1920 Kbps can be entered.
Restrict
Selects the ISDN transmission rate when
dialing or answering.
Auto: Selects when connecting a remote
party via a normal ISDN line.
56K: Selects when connecting a remote
party in a region or country where the
ISDN transmission rate is 56 Kbps.
The system is set to connect an ISDN line at the
transmission rate of 64 Kbps at the factory.
However, some countries such as the USA or
some regions may use the ISDN transmission
rate of 64 Kbps and 56 Kbps. You may not
communicate with such country or region with
the transmission rate of 64 Kbps. In this case,
set “Restrict” to “56K” before dialing.
Page 2/2
Video Mode
Selects the compression format of the
pictures for a multipoint conference.
ALL: Uses any video compression format
depending on the format used on the
remote sites.
H.263: Uses pictures based on
Recommendation H.263.
H.261: Uses pictures based on
Recommendation H.261.
Audio Mode
Selects the audio compression format for a
multipoint conference.
ALL: Uses any audio compression format
depending on the format used on the
remote site.
G.722: Uses audio based on the G.722
standard.
G.728: Uses audio based on the G.728
standard.
G.711: Uses audio based on the G.711
standard.
When the remote videoconferencing system
does not support the Audio Mode selected by
the local site, the mode automatically switches
to “G.711”.
Display Terminal Name
Selects whether you display the connected
terminal names on the monitor screen at the
time of disconnection.
On: Displays the terminal names.
Off: Does not display terminal names.
Far End Camera Control
Selects whether to enable control of each
other’s cameras from each other sites.
On: Enables control of each other’s
cameras. Normally, set to ON.
Off: Disables control of each other’s
cameras.
The Audio Setup menu is used to set various
audio items.
Input Select
Selects the sound to be input.
MIC: Inputs the sound of the microphone.
AUX: Inputs the sound from external
equipment.
MIC+AUX: Inputs both sounds from the
microphone and external equipment.
Note
Page: 2/2
ALL
Multipoint Setup
Video Mode
ALL Audio Mode
On Display Terminal Name
On Far End Camera Control
Save Cancel
Note
Audio Setup Menu
Page: 1/1
Audio Setup
Input Select
Internal
MIC
MIC Select
Off Lip Sync
On Beep Sound
On Recording Mute
Save Cancel
Internal Echo Canceler