Top Innovations CF-980 - Manual (Page 9)

9 Top Innovations, Inc.
U
SING THE
C
ENTURION TM
FILLING WATER RESERVOIR
1) Release Locking Handle and pull it back to rest on top of Power
Cord Holders.
2) Carefully remove main unit from removable water tank and set it
aside.
3) Using Lift Handle in bottom of removable water tank, lift water tank
out of cradle car, and carry it to a convenient sink or tub.
4) Remove Suction Tube from Suction Tube Inlet, fully exposing inlet
hole. Note that this step is not necessary, but may make it easier to pour
water into Water Reservoir.
5) Begin pouring water through inlet hole into Water Reservoir.
Ordinary tap water of mild temperature is ideal.
IMPORTANT: When pouring water into Water Reservoir, DO
NOT exceed Maximum Fill Line mark on side of removable water
tank. Doing so may cause damage to main unit motor.
6) Replace Removable Suction Tube into Suction Tube Inlet (if you
chose to remove it in Step 4).
7) Once again using Lift Handle, carefully place filled water tank back
onto cradle car.
8) Replace main unit back into removable water tank, and return
Locking Handle to its upright position to secure the unit together.