Tyco Electronics M/A-COM MM23016 - Manual (Page 65)

MM23016, Rev. C
65
programmed to provide Trunked Priority Group Scan capability, which operates similar to priority scan in
Conventional mode.
The following is a description of programmable scan features that should be helpful in understanding the
Group Scan Operation of the radio:
Scan Hang Time - the delay time the radio waits before resuming scan after the push-to-talk is released
or after the carrier has dropped a channel.
TX Select - the group the radio will transmit on while scanning. The radio is programmed to transmit on
either the scanned group or the selected group.
Scan List (privileges) - this feature allows or prohibits scan list changes by the user.
P1 Programming - priority group programming is accomplished by one (and only one) of three methods:
•
From the keypad, where the Priority programming is not fixed and does not follow the selected
channel,
• Priority 1 group programming follows the selected channel, or
•
Priority 1 group programming is fixed during PC programming and cannot be changed by the user.
P1 Always Scan - determines if the Priority 1 Group will always be scanned, regardless of the scan state
set by the user.
9.10.1 Adding Groups to a Scan List
1. With scan operation turned off, select the desired group to add to the selected Trunked system group
scan list.
2. Press (
+) or (-) with
to display the current priority status of the group on line 1 for a time-out
period.
3. While the status is displayed, press (
+) with
to add the group to the scan list. is displayed.
4. Press (
+) with
a second time to set the group to Priority 2. is displayed.
5. Press (
+) with
a third time to set the group to Priority 1. is displayed in column 1, line 1.
The priority level selection sequence only advances the group to next higher priority level and stops
at priority level 1. To select a lower priority level, the group must be deleted from the scan list and
then added back to the scan list. Each new group added to the scan list starts at the lowest priority. If
the Priority 1 and Priority 2 groups are already set and a new group is assigned as Priority 1 or
Priority 2, the previously assigned group will change to non-priority scanning.
9.10.2 Deleting Groups from a Scan List
1. With scan operation turned off, select the desired group to delete from the selected trunked system's
group scan list.
2. Press (
+) or (-) with
. The current scan status of the group is displayed for a time-out period.
3. Press (
-) with
to delete the group from the scan list. , or turns off. Any group that is
not in a trunked system group scan list will show a “blank” when it is the selected channel.