Tascam CD-601MKII - Manual (Page 2)

CD-601
MK
II/RC-601
MK
II
Quick Start Guide
»
2
Connection
To mixer, amplifier, etc.
To RC-601 MK II
If you have the RC-601MKII remote control unit, connect
the PLAYER UNIT port on the RC-601MKII rear panel
to the REMOTE (SERIAL) port on the CD-601MKII rear
panel using the cable supplied with the RC-601MKII.
• Make audio connection between the CD-601MKII
outputs and an external audio device.
As described above, by default, both online and monitor
playback signals are output from all the outputs. Therefore,
you simply use the appropriate output connector(s) on the
CD-601MKII that match the connector(s) of the external
device.
Playing back a desired track
(SINGLE PLAY)
The following describes the procedure for selecting
a desired track, checking the track using the monitor
playback function, and executing online playback.
1. Press the PLAY MODE key to light "SINGLE" on the
left of the display.
2. Press the PLAY/PAUSE key on the CD-601MKII (or
the PAUSE key on the RC-601MKII) to enter "monitor
pause".
3. Use the TRACK keys (or the numeric keys on the
RC-601MKII) to select a desired track for playback.
The CD-601MKII enters "monitor pause" at the
beginning of the selected track.
4. To check the track sound, press the PLAY/PAUSE key
on the CD-601MKII (or the MONITOR key on the
RC-601MKII) to start "monitor playback".
5. If the track is OK, press the READY key.
The CD-601MKII locates to the beginning of the audio
of the track.
6. Press the ON LINE key to start "online playback".
At the end of the track, the CD-601MKII automatically
stops.
Playing back from the desired point
on a track
To play back from the desired point on a track, follow the
procedure below after selecting a desired track on step 3 in
"Playing back a desired track (SINGLE PLAY)" above.
4. Search the desired point using the SEARCH keys on the
CD-601MKII, or the JOG/DATA dial or the SEARCH
dial on the RC-601MKII.
Note
You can also use the monitor playback function to
move forwards by pressing the PLAY/PAUSE key
on the CD-601MKII or the MONITOR key on the
RC-601MKII. If you do so, pause the CD-601MKII
at the desired point by pressing the PLAY/PAUSE
key on the CD-601MKII or the PAUSE key on the
RC-601MKII.
5. Press the PLAY/PAUSE key on the CD-601MKII or the
MONITOR key on the RC-601MKII to enter "monitor
playback" for checking the point.
6. If the point is OK, press the READY key.
The CD-601MKII locates to the point you set in step 5
above.
If you want to trim the point, press the PLAY/PAUSE
key on the CD-601MKII or the PAUSE key on the
RC-601MKII to enter "monitor pause", and go back to
step 5 above.
7. Press the ON LINE key to start "online playback".
At the end of the track, the CD-601MKII automatically
stops.