TC electronic SDN BHD Gold Channel - Manual (Page 17)

SETUP - Level
17
The Level display
On the Level page you can adjust the Digital Input level, the Master Level for all outputs and the Analog Output level
for channels one and two.
To view the Level display, press the SETUP key if you are not already there, and use the < > Menu keys to select the Level page.
Basic operation is accomplished by using the Parameter wheel to change cursor position and the value wheel to change values.
“Level” page selected
Analog output levels
Master output levels
for all outputs
Digital input levels
Adjusting the levels
Use the parameter wheel to move the cursor and select what level
you will adjust, either one channel at a time or both
simultaneously. Use the Value wheel to adjust the levels. If you
have different levels on each channel, adjusting both channels
will preserve the difference until you reach the maximum or
minimum level on one of the channels.
Digital input levels
These parameters control the digital input if you have selected it
on one or both channels. If you are not using a Digital input, the
bars will be grayed out, and you have no access to adjust them.
The digital input level is parallel to the analog input gain, and
therefore has no effect on the analog input level.
Master output levels
These parameters control the output level for all outputs except
Insert Send if chosen. In the signal chain they are placed right
after the panners in the output section (see the Edit display).
It is possible to remote control the Master output level by
connecting an optional TC Master Fader via the External 1/4”
jack input at the back panel. In Utility/Config menu you can
choose whether it shall control Ch.1, Ch.2 or both.
Analog output levels
These “knobs” control the analog output level for each channel,
and are placed right after the DA converters. This means that the
Master level will affect the Analog output level controls (Except
if the analog outputs are used for Insert Send)
When grayed out, analog
input is selected