Technicolor - Thomson DPL560HT - Manual (Page 23)

20
Advanced Sound Control
Stereo
The Stereo mode uses the two main channel outputs
from the front speakers. Use this mode if you have
connected the front speakers only.
DSP (Digital Sound Processor)
These digital sound effects resemble sounds in a real
environment such as
(STADIUM/CONCERT/THEATRE/ARENA/CHURCH/CLUB/) . DSP
automatically converts analog audio signals to digital
ones which enables you to adjust the sound without
degrading the sound quality. Different modes will
give you different feel of size and type of listening
environment. (Not available in Dolby Digital (DVD))
Fine Setting of the Components
The receiver has pre-selected surround mode once
you turn on the unit by pressing the Source Buttons
(like DVD, SAT, CD) directly. The default surround
modes for different components are listed in the
table below.
If you decide to change the surround mode, you can
press the SURR MODE repeatedly to toggle among
the different surround mode choices and select the
one you want.
Pro Logic Stereo
The receiver will keep the last selection in memory.
Input Signal Setting
The receiver defaults to the most convenient settings
for your easiest use (see table).
If your connection is different from the default set-
ting,
1. Select the source
2. Press DIGITAL INPUT button to toggle among opti-
cal/ coaxial/ analog to match your connection. Your
selection will be stored automatically.
The selected source and input source will be displayed
on the display as long as they are active, except for
some temporary change of display (e.g. adjusting vol-
ume).
Digital Input
Select this setting to play digital signals from a DVD,
CD, LD player, SAT or TV.
Analog Input
Select this setting to play analog signals from a cas-
sette deck, VCR or turntable.
Source/ If Digital Input (optical If Analog Input
Input or coaxial) is selected is selected
DVD Dolby Digital/PRO LOGIC PRO LOGIC
SAT Dolby Digital/PRO LOGIC PRO LOGIC
VCR N/A PRO LOGIC
V-AUX N/A PRO LOGIC
TV Dolby Digital/PRO LOGIC PRO LOGIC
CD STEREO STEREO
TAPE N/A STEREO
TUNER N/A STEREO
DEFAULT INPUT (as seen on display)
Analog (SAT/ ANL)
Analog (DVD/ ANL)
Analog (CD/ ANL)
Analog (VCR/ ANL)
Analog (VAUX/ ANL)
Built-in Tuner
Analog (TAPE/ ANL)
Analog (TV / ANL) SOURCE
SAT
DVD
CD
VCR
V-AUX
FM/AM
TAPE
TV
N O T E
Digital input is only available for DVD, SAT, CD
and TV
AVAILABLE INPUT
ANL/Optical/Coaxial
ANL/Optical/Coaxial
ANL/Optical/Coaxial
ANL/ - / -
ANL/ - / -
ANL/ - / -
ANL/ Optical / - SOURCE
SAT
DVD
CD
VCR
V-AUX
TAPE
TV
DPL560-EN 4/11/02 5:28 PM Page 24