Toto LVU2E1 - Manual (Page 8)

ENGLISH - 6 -
See the table below to check in what orientation ME551i2 is.
Display mode LED behavior upon turn-on
Portrait (default)
The LED blinks just once.
Landscape
The LED blinks twice.
1 Connect one end of the DVI cable supplied with the display to LVU2E1 and the other
end to the display and tighten the screws on the connectors.
Careful not to break the connector pins by trying to insert the DVI connector at
an angle.
Caution
Graphics card connectors (female):
Note:
• LVU2E1 has two DVI connectors. Make sure to connect the fi rst display to
Connector 1 on the left when the card is placed face up.
• LVU2E1 has two dual-link DVI connectors. To use LVU2E1 in dual-link mode, a
display and a DVI cable that support dual-link are required. Use the DVI cable
supplied with the dual-link display.
DVI Connector 2
Connect the second
display (on the right)
DVI Connector 1
Connect the fi rst display
(on the left)
DVI cable connector (male):
Dual- and single-link support Single-link only
Do not connect/disconnect the DVI cable while the display is turned on. It could
cause a graphics card failure. Connect/disconnect the DVI cables with the
display disconnected.
Caution