Rear panel, Box contents, The remote control – Technicolor - Thomson TU-SZT105A User Manual
Page 5: Preparing the remote control, 3 the remote control
2.2 Rear
Panel
• DC Power Mains: (100 - 250VAC~; 50/60 Hz), Power 15W Max.
• RF IN: Used for connection of the cable from your outdoor terrestrial TV antenna.
• RF OUT: Used for connection to your TV RF antenna Input or your VCR RF Input.
• AUDIO: (connectors L and R) is used for analogue stereo audio output connection
to analogue TV or VCR.
• Digital Audio: SPDIF output for connection to your TV or other A / V receiver (eg
home theatre system).
• Component Video / RGB / Video (SCART): Used for connection to your TV set.
• Serial Port (RS232): Used for system maintenance only.
2.3 Box
Contents
The box that carries your Digital TV Receiver should also contain the following items:
z
Remote
Control
z
Two Batteries (AAA Size)
z
SCART to RCA Connector Cable
z
RF
Cable
z
User’s Manual and Warranty Card
3 The Remote Control
3.1 Preparing the Remote Control
z
Remove the cover of the battery compartment (on the back of the remote control)
z
Insert 2 AAA (1.5V) batteries. While inserting, observe the + and – markings
indicated inside the battery compartment.
z
Replace the cover
z
Test the remote control by pressing the
key and toggle the unit from
standby to normal viewing ON mode and observe the light on the front panel
toggles between red (standby mode) to green (normal viewing ON mode).
5