Ta-880 – Turbosound ASPECT TA-880 User Manual
Page 33
user manual
TA-880
TA-880 user manual
Page 33
Flying a single TA-880 trapezoidal cabinet using FC-880 chains
A single cabinet can be flown using a pair of FC-880S short chains and daggers. These
simply pass through slots in the top of the cabinet and are secured with safety linch-pins
inside the handle boxes. Connect FC-880S short flying chains to the appropriate suspension
tabs on the flybar and check that the daggers line up with the slots. In the diagrams below
only one dagger is shown for clarity.
1. Insert a dagger through the slot machined in the top of the cabinet and into the handle box
as illustrated in the cutaway drawing above. The tip of the dagger located in the sword box
will be visible through the handle hole. Repeat with the second flying chain and dagger.
2. Insert a SL-880 safety linch-pin through the small hole in the dagger from the outside of
the box, and secure it by snapping the safety linch-pin so that it loops around the back of the
dagger. Repeat with the second linch-pin and dagger.
3. When the cabinet is lifted the dagger is held in place by the safety linch-pin, while the slot
allows the cabinet to be freely tilted.