Teledyne WIRELESS COMMUNICATION MODULE 2102 - Manual (Page 25)

4-1
2102 Wireless Communication Module
Section 4 Programming
4.1 Section Overview This section describes how to set up the operation of a 2100
Parameter Module using Teledyne Teledyne Isco’s Flowlink for
Windows software.
Note
The 2100 System requires Flowlink 4.1 or later. Earlier ver-
sions do not support 2100 System instruments.
Flowlink Help Detailed Flowlink instructions are beyond the scope of this
manual. Flowlink’s operating instructions are available in a
Windows Help format. You can access the help topics for an
active window by clicking on its Help button or by pressing F1 on
your computer’s keyboard. You can also access Help topics from a
Contents and Index window (H
ELP >C ONTENTS AND I NDEX from
the Flowlink menu).
4.2 Flowlink Connections Make the necessary wiring connections to allow your computer to
communicate with the site. Figure 4-1 shows a connection using
Teledyne Teledyne Isco’s Communication Cable, P/N 60-2004-046
(or 60-5314-849 for custom length).
There are two ways to connect to a site using a wireless base unit
and Flowlink:
• Quick-Connect method - From the Quick-Connect dialog,
select Wireless and then press the correct button to
select the appropriate type of unit. Note that when using
this connection method, you should select the button
containing the type of equipment to which the remote is
connected. A list of all the sites will appear. You have the
option of selecting the site or entering the site name and
connecting. You need to know only the site name when
connecting to a remote.
• Open Existing Site method - Assuming the site already
exists, you may simply open the site and connect or
right-click on the site and connect. If a problem occurs,
you should confirm that the Site Info tab has Wireless
selected for the type of communication.