TP-Link TR-966D - Manual (Page 4)

2 3
 Auto-detection of half/full duplex transfer mode for RJ45
port.
 Auto-negotiation of 10/100Mbps rate and Auto-MDIX for
RJ45 port.
 Fiber port only support full duplex transfer.
 Extend fiber distance up to 20km for fiber port.
 Easy-to-view LED indicators provide status to easily monitor
network activity.
 External power supply.
Network Cable Supported
The connectors and network cables supported by the TR-966D
are listed in the following:
 RJ45 port: Cat 5 Twisted-pair
 SC Fiber port: single-mode fiber cable
Appearance Indication
1. Front Panel
The front panel of the TR-966D consists of several LED
indicators
T1_SPD T2_SPD F2_LINK/ACT F1_LINK/ACT POWER T2_LINK/ACT T1_LINK/ACT
10/100M Fiber Bridge WDM
TR-966D
TR-966D Front Panel
2. Rear Panel
The rear panel of the TR-966D consists of one AC power
connector, two 10/100Mbps RJ45 ports and two SC Fiber
interfaces.
POWER T1 F2 F1 T2
TR-966D Rear Panel
3. LED Indicators
This TR-966D has LED indicators which can provide a real-
time report. When you take a look at these indicators, you will
know what’s happening your network.
 Power(Red): Lights when the adapter is properly plugged in.
 T1_SPD/T2_SPD(Green): Light when the RJ45 port is
connected to 100Mbps device; When the port connect to
a 10Mbps device, the LED turns off.