TP-Link TR-966D - Manual (Page 5)

4 5
 T1_Link/ Act/ T2_Link/ Act(Green): Steady green
indicates that a valid link exists. Flashing green indicates
that the TR-966D is receiving or transmitting data from the
RJ-45 port.
 F1_Link/Act/ F2_Link/Act (Green): Steady green
indicates that a valid link exists. Flashing green indicates
that the TR-966D is receiving or transmitting data from
the fiber port.
Installation Guide
1. Configuration
In order to achieve the aim of effectively expanding a Fast
Ethernet network, you can use the TR-966D as the example.
2. Installation procedure:
A. Connect the TR-966D to 10/100Base-TX Device (Hub or
Switch).
 Make sure that the length of twisted pair cable (Category-
5) between 10/100Base-TX device and converter is not
longer than 100 meters.
 Connect one end of twisted pair cable to RJ45 jack on the
TR-966D and the other end of the cable to the cable to
the RJ-45 jack on the 10/100Base-TX device.
B. Connect the TR-966D to 100Base-FX Device
Connection.
Connect on (SC) end of a singl-mode fiber cable to the SC
connector F1/F2 on the TR-966D and the other end of
the cable to 100Base-FX device.
C. Turn on the device.
Notes:
The WDM technology employs passive optic multiplexing,
thus multiplex the transmit (TX) and receive (RX) lines onto a
single fiber. WDM technology is implemented in couples. For
example, one site uses the F1 fiber port on the TR-966D, the
other site uses DEVICE A, the fiber port on DEVICE A must be
1550nm/1310nm WDM fiber; One site uses the F2 fiber port on
the TR-966D, the other site uses DEVICE B, the fiber port on
DEVICE B must be 1310nm/1550nm WDM fiber.