The Singing Machine STVG-535 - Manual (Page 12)

E11
PREPARATION
PLAYING CD OR CD+G DISC
TURNING POWER ON/OFF
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
This unit is designed to play CD’s bearing the identification logo . If CD’s do not
conform to the CD standard, they may not play properly.
Fingerprints and dust should be carefully wiped off with a soft cloth. Wipe in a straight motion
from the center of the disc to the outside edge.
Never use chemicals, such as record cleaning sprays, antistatic sprays or fluids, benzene or
thinner to clean compact discs. These chemicals will permanently damage the plastic
surface of the disc.
Always place the compact disc on the disc tray with the label facing upward. Compact discs
can be played on only one side.
To remove a disc from its storage case, press down on the center of the case and lift the disc
out, holding it carefully by the edges.
Discs should be returned to their cases after use to protect them from dust and scratches.
To prevent warping the disc, do not expose it to direct sunlight, high humidity or high
temperatures for extended periods of time.
Do not apply paper or write anything on either side of the disc. The inks used in some felt-tips
pens may damage the surfaces of the disc.
Adjust MASTER VOLUME control on your unit, TV or audio system to a comfortable level.
Adjust MIC/ECHO/BALANCE controls as needed to achieve the desired mix of music and
vocals through your TV or sound system.
Do not press the disc cover of the CD compartment while it’s playing.
Never place anything except a compact disc on the disc tray. Foreign objects can damage
the unit.
Do not apply excessive force to the disc cover.
Only place one disc on the disc tray at a time.
To turn off the system, press the ON/OFF button again, the ON/OFF LED will turn off.
" "
!
!
!
!
!
!
!
To power on the karaoke center, press the ON/OFF button, the ON/OFF LED will illuminate.
To play a CDG, set MONITOR Selector to either CAMERA, CDG/AUX or OFF mode.
To display the CDG lyrics on the Singing Machine’s monitor, set MONITOR Selector to
CDG/AUX mode.
To turn off the monitor on the Singing Machine, set MONITOR Selector to OFF mode.
Adjust the BRIGHTNESS, CONTRAST and VERTICAL HOLD knobs located under the
monitor of the Singing Machine to display the best picture quality.
FUNCTION SELECT
MONITOR SELECT
LOADING A DISC
Set the FUNCTION SELECT switch to CD+G.
Press the CD door OPEN button to open the CD compartment door. Place a disc in the
compartment with the printing side facing upward and the shiny side facing down.
Press the CLOSE point (for CD door) again to close the CD compartment. The LED window
will display total number of track. (If no disc is loaded, it will display “
”).
(Refer to the Trouble Shooting Guide on page E16 if a disc is loaded but the total tracks
do not appear.)
CD OR CD+G OPERATION
ENGLISH