TRENDnet TEW-435BRM - Manual (Page 10)

Installation
7
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the TEW-
435BRM. Both 10BaseT and 100BaseT connections can be used simultaneously.
If required, connect any port to a normal port on another Hub, using a standard LAN cable.
Any LAN port on the TEW-435BRM will automatically function as an "Uplink" port
when required.
3. Connect ADSL Cable
Connect the supplied ADSL cable from to the WAN port on the TEW-435BRM (the RJ11
connector) to the ADSL terminator provided by your phone company.
4. Power Up
Connect the supplied power adapter to the TEW-435BRM and power up.
Use only the power adapter provided. Using a different one may cause hardware damage
5. Check the LEDs
• The Power LED should be ON.
• The Status LED should flash, then turn Off. If it stays on or blinking after 60 seconds,
there is a hardware error.
• For each LAN (PC) connection, one of the LAN LEDs should be ON (provided the PC is
also ON.)
• The WLAN LED should be ON
• The WAN LED should be ON if ADSL line is connected.
For more information, refer to Front-mounted LEDs in Chapter 1.