Topfield TF 6000 PVR - Manual (Page 61)

6.5 Editing channel data on your computer 53
1. Plug one end of a RS-232 cable (9 pin D-
sub cable) into the RS-232 port on the dig-
ital receiver, and the other end into the
matching port on the other digital receiver.
2. Turn on the source digital receiver.
3. Select the Installation > Transfer Firmware
> Transfer Data to Other IRD menu, then
you get asked for confirmation; select Yes.
4. To start the data transfer, turn on the target
digital receiver.
5. A progress bar appears showing the
progress of the data transfer.
6. Restart the target digital receiver when the
data transfer is complete.
6.5 Editing channel data on your computer
You can edit the channel data on your computer by using a
channel editor programme, Vega. With Vega you can do the
following:
• Adding, deleting or modifying satellite entries
• Adding, deleting or modifying transponder entries
• Deleting or modifying service entries
• Adding, deleting or modifying favourite groups
You can not only transfer your channel data to the digital
receiver but also save it as a file, the extension name of
which is std. Vega is available from the Topfield website,
http://www.i-topfield.com .
To use Vega, you have to prepare either a USB cable or a RS-232
cable to link the digital receiver with your computer.