Toshiba IK-TF9U - Manual (Page 22)

22
• Serial baud rate 9600, 19200
-- OPTION --
BAUD RATE
9600
Move up down
By pushing
MENU UP, DOWN
Set by pushing
DATA UP, DOWN
(4. 5) Changing the shading correction mode
1 Set the "
→
" to SHAD. by pushing [MENU UP], [MENU DOWN] buttons.
2 Set the SHAD. by pushing [DATA UP], [DATA DOWN] buttons.
Note: The alignment value for shading is fixed to "0" when selecting SHAD. OFF. MANU is not dis-
played in the menu.
(4. 6) Changing the manual shading correction setting
1 Set the " → " to MANU by pushing [MENU UP], [MENU DOWN] buttons.
2 Set the MANUAL SHADING by pushing [DATA UP], [DATA DOWN] buttons.
( 6 ) OPTION
(6. 1) Changing serial communication baud rate
1 Set the "
→
" to BAUD RATE by pushing [MENU UP], [MENU DOWN] buttons.
2 Select either 9600 or 19200 by pushing [DATA UP], [DATA DOWN] buttons.
• H PHASE -100 to 100
• Sync system display
-- SYNC --
MODE EXT
H PHASE
0
Move up down
By pushing
MENU UP, DOWN
Set by pushing
DATA UP, DOWN
(5. 1) Adjusting horizontal phase
1 Set the " → " to H PHASE by pushing [MENU UP], [MENU DOWN] buttons.
2 Adjust the horizontal phase by pushing [DATA UP], [DATA DOWN] buttons.
( 5 ) SYNC
When an external sync signal is input, the display menu changes from INT (internal sync) to EXT (external
sync) automatically.