TIC WRS010 - Manual (Page 11)

11
Troubleshooting…
No Sound? Transmitter is not initialized – Re-check the
power is “on” at the transmitter and try changing
“channels at the transmitter.
Check the audio signal source both to and from
the transmitter. Try another cable to ensure
integrity.
Check the receiver amplifier, if used, is powered
“on” at the mains, is not on “mute”, has no
headphones attached and that the Channels
used for the transmitter/ exterior speakers
(usually A or B) is in operation.
Refer to the owners guide that came with your
receiver amplifier.
Check the “on” switch at the Remote Control to
make sure the speaker is switched “on”.
Check the volume control on your Remote
Control is switched high enough for volume to
be heard.
Check the “Green” indicator light on your
speakers to ensure they are receiving a signal.
Ensure you speakers are receiving power. Red
LED..
No Sound from one
speaker Check the “balance” control on your receiver
amplifier is “equal”.
Check all connections and cable to and from, or
the integrity of the transmitter source to the
inoperable speaker.
Check the batteries or power source(s) to the
inoperable speaker.
Speaker has
intermittent or rough
sound; the distance
of the remote
control volume
controller becomes
nearer Loudspeaker is flashing red or full light – the
battery of the loudspeaker or remote control will
soon be out of power. Please replace.
Check the “range” by temporarily bringing the
exterior speakers closer to the transmitter
source.
Lift the transmitter height to see if this has any
effect.
One speaker
sounds distorted,
lower volume Follow same procedure as above for “No
Sound”