Telex PW24N - Manual (Page 3)

Revision B Page 3 of 9 12/11/08
QUICK SET UP AND OPERATION
Synching Up The Transmitter and Base The synch operation only needs to be performed
the first time a system is used, or a new bodypack is used with a base previously synched to
another bodypack. Do not perform the synch operation multiple times; it only needs to
be done one time when a new bodypack is used with a new base.
1) Turn the transmitter power switch to ON and place the transmitter in the
recharge cradle of the base. The transmitter goes in the base with the
beltclip facing out.
2) The recharge LED will light (Green if fully charged, Red if charging). Leave
the transmitter in the cradle for 4 hours for a full charge.
3) Press the In-Use button on the transmitter and hold until the In-Use LED on
the transmitter and base start to flash, then release the button.
4) After a few seconds the light will stop flashing, and a beep will sound (If the
beep is enabled).
5) The transmitter and base are now synched and will continue to be until
another transmitter is linked to that base.
Normal Operation
1) With the transmitter synched up, remove it from the cradle, plug in the lapel
microphone (if used) and place the transmitter on your belt.
2) To start the recording, press the In-Use button and the In-Use LED will light a
constant green and you will hear a short beep
3) To end recording, press the In-Use button and the In-Use LED will turn off
and you will hear a short beep.
4) At the end of your shift turn the transmitter off and replace it in the charging
cradle.
Out of Range
1) If you use the Transmitter too far away from the Receiver during recording,
the transmitter will alert you with Audible warning beeps (two tone) and the
In-Use LED will blink in red.
2) Move closer to the receiver base and the link will be re-established once you
return to normal range. The In-Use LED will light constant green when link is
back to normal operation.
3) If the link is not re-established within 30 seconds, the transmitter and receiver
will return to standby mode.
4) If you went out of range in Standby mode, or the unit reverted to standby
mode, re-enter normal range and press the In-Use button. Operation will
return to normal.
5) If you will be out of range for a long period of time, turn the bodypack off.
Low Battery Warning
1) If the transmitter Low BATT indicator (red) starts flashing or you hear warning
beeps, return the transmitter to its cradle on the receiver to fully charge the
transmitter.
2) The Charge LED indicator will light constant green when the unit is fully
charged.