Telex PW24N - Manual (Page 5)

Revision B Page 5 of 9 12/11/08
2. Plug the 3.5mm stereo plug into the audio input jack of the recording device.
3. If it is to be used, plug in the in-car microphone into the In-Car Mic jack in the side of the
receiver base.
4. Turn on the transmitter and place it in the charging cradle with the beltclip facing out.
The Charge LED will light if there is power. If the LEDs do not come on, check the
connections and repeat.
Installation is complete. Refer to Operation Section for more information.
Description Position
Inside Car Mic Audio Tip
Transmitter Audio Ring
Audio Ground Sleeve
Sleeve
Ring
Tip