Technics SA-DX1050 - Manual (Page 20)

Enjoying the sounds
20
RQT5802
You can adjust the tone (BASS and TREBLE) only when the DSP
sound mode is STEREO and input is either analogue or PCM. You
cannot adjust the tone while the DSP is defeated or if DVD 6CH
INPUT is selected.
1
Press [BASS/TREBLE, BALANCE].
Each time you press the button:
BASS
/ TREBLE / BALANCE
↑
BASS: To adjust the bass
TREBLE: To adjust the treble
BALANCE: To adjust the left/right sound balance
2
Press [–, L] or [+, R].
–, L: to lower the selected tone or shift the balance to the left
speaker.
+, R: to raise the selected tone or shift the balance to the
right speaker.
The previous display returns after a few seconds.
Adjusting the tone and balance
This button only works when “VCR 1” is selected as the input
source.
Press [VCR 1 l , VCR 2 k ] to select
“VCR 1 l ” or “VCR 2 k ”.
SA-DX1050 only
Using the VCR 2 terminals
Using headphones
1 2
1
2
VCR 1
VCR 2
B
A A
B
C
BASS/TREBLE
BALANCE
L R
– +
–10 dB +10 dB
BASS, TREBLE
BALANCE
VCR 1
VCR 2
1 3 2 4
C
a Headphones
q q Press [A] and/or [B] to turn off the speakers.
Turning the speakers off automatically engages STEREO mode
and ensures no sound is heard from the subwoofer.
(Sound will seem unusual if you use another DSP mode.)
w w Reduce the volume.
e e Connect the headphones (not included).
Plug type: 6.3 mm stereo
r r Adjust the volume.
Avoid listening for prolonged periods of time to prevent hearing
damage.
Note