Technics SA-DX1050 - Manual (Page 27)

27
RQT5802
Ref
erence
Timer function
There are two timer functions: the sleep timer and the wake timer.
¡ ¡ Sleep timer:
The unit turns off after a set time.
It can be set for 30, 60, or 90 minutes.
¡ ¡ Wake timer:
The unit can be set to turn on a certain number of hours after it is
turned off.
It can be set for 5, 7, or 9 hours.
Note
1
Press [TIMER, -MODE, –TIME] to
select the desired timer mode.
2
[Within 5 seconds]
Press [TIMER, -MODE, –TIME] and
release when the time you require is
displayed.
The display changes as follows:
¡ In sleep timer mode
30
/ 60 / 90 (minutes)
↑
¡ In wake timer mode
5H
/ 7H / 9H (hours)
↑
The display is restored 5 seconds after the setting is
completed.
3
Press [ 8 ] to turn off the unit.
The “WAKE” indicator lights up.
Checking the remaining time on the sleep timer and the
time set for the wake timer
Press [TIMER, -MODE, –TIME] once.
Do not press [TIMER, -MODE, –TIME] again before the remaining
time indication goes out.
The setting may change if you do this.
Changing a setting
Repeat steps 1 and 2.
To cancel the timer
Press [TIMER, -MODE, –TIME] until “OFF” is displayed.
“SLEEP” or “WAKE” will go out.
¡ The timers cannot be used together.
¡ The sleep timer turns off the receiver, and the wake timer turns
on the receiver, but they do not turn off/on any externally
connected components.
Note
Note
Wake timer mode only
Setting the timers
12 3
WAKE
12 3
WAKE
1
2
-MODE
–TIME
TIMER
-MODE
–TIME
TIMER
3
SLEEP
WAKE
WAKE
MHz
WAKE
For Europe
For Australia and New Zealand