Technicolor - Thomson ASR08T - Manual (Page 7)

8
ENGLISH
INSTALLATION OF SATELLITE RECEIVER
- Connect the LNB coaxial cable to Socket ብ IF INPUT A.
- You can, if applicable, connect a second LNB to IF INPUT B connector ቦ. Plug F must be
tightened by hand on the threading of the plug. Do not use any tools. Take care not to jam
the plug.
- You can now connect your equipment to the mains power supply. To do this, connect one of
the ends of the mains cable to connector ቫ on the receiver and the other end to a mains
socket.
Our description of the receiver assumes that the set has been installed according to
instructions!
1. Connection to a Television Set :
- Using a SCART cable (supplied), connect the Socket
ቧ TV-SCART of your receiver to the
SCART socket of your Television Set. This connection provides optimum picture and sound
quality.
2. Connection to a VCR :
- Using a SCART cable (not supplied), connect the Socket
ቩ VCR-SCART of your receiver
to the SCART socket of your VCR.
The equipment is operated using a cascade connection.
The video recorder images will be transmitted to the TV through the TV SCART connector
ቧ if the video recorder supplies the control voltage when it is in read mode (12V on pin
8 of the VCR SCART connector
ቩ).
3. Connection to a decoder
Using a SCART cable (not supplied), connect the Socket
ቨ DECODER-SCART of your
receiver to the SCART socket of your decoder.
4. Connection to a stereo system :
Your satellite receiver can be connected to a stereo system using the CINCH connectors
ቪ.