TP-Link TL-SF1016 - Manual (Page 6)

3
Chapter 2 Identifying External Components
This Chapter describes the front panel, rear panel and LED indicators of the
Switch.
2.1 Front Panel
The front panel of TL-SF1016 consists of switch model, switch LED indicators, and
16 10/100Mbps RJ-45 ports.
Figure 2-1 TL-SF1016 Switch Front Panel sketch
The LED indicators include Power, Link/Act LED indicators, which are used for
monitoring and pre-troubleshooting of the Switch. The following section shows the
LED indicators of the Switch along with an explanation of each indicator.
¾ Power LED: This indicator will light solid red when the Switch powers up. If
the LED is not lit, please check the power supply and connection.
¾ Link/Act LED: The LED indicates Link/Active status. The corresponding LED
indicator will light solid green when connected to a network device. It flashes
green when data is being transmitted or received on the working connection.
¾ 100Mbps: The corresponding port LED indicator will light solid green when
it's working on 100Mbps speed. Not lit indicates working on 10Mbps speed.
Note:
Because of the difference among the mode of switch, some switches don’t include
the 100Mbps indicator, such as TL-SF1048 and a few of TL-SF1016 switch.
2.2 Rear Panel
The rear panel of TL-SF1016 features a power socket and a Grounding Terminal
(marked with
).
Figure 2-2 TL-SF1016 Switch Rear Panel sketch