TANDBERG D14041.02 - Manual (Page 29)

25
TANDBERG FieldView Device User Guide D14041.02 January 2008
equipment in a residential area is
likely to cause harmful interference in
which case the user will be required
to correct the interference at his own
expense.
This equipment was tested for RF
Exposure compliance and meets the
requirements with Maximum Peak
Spatial-Average SAR1g of 0.01 W/kg.
No metallic accessories should be
used with this device and multiple
devices should not be co-located at a
distance of less than 20 cm.
Caution: Changes or modifications
that are not expressly approved
by the manufacturer could void
the user’s authority to operate this
equipment.
FCC Class B Notice (S/N: 001100
and higher)
This product has been tested
and found to comply with the
limits for a Class B digital device,
pursuant to Part 15 of the FCC
Rules. These rules are designed
to provide reasonable protection
against harmful interference in a
residential installation. This product
generates, uses, and can radiate
radio frequency energy, and if not
installed and used in accordance
with the instructions, may cause
harmful interference with radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If the equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment on and
off, the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment to an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an
experienced radio/TV technician for
help.
Caution: Changes or modifications
that are not expressly approved
by the manufacturer could void
the user’s authority to operate this
equipment.
Industry Canada Class A Notice
(S/N: 001000 – 001099)
This Class A digital apparatus
complies with Canadian ICES-003.
Cet appareil numérique de classe A
est conforme à la norme NMB-003 du
Canada.
Industry Canada Class B Notice
(S/N: 001100 and higher)
This Class B digital apparatus
complies with Canadian ICES-003.
Cet appareil numérique de classe B
est conforme à la norme NMB-003 du
Canada.
Safety Notice
The mobile streaming camera,
Model was evaluated to IEC
60950-1:2001, EN60950-1:2001,
UL 60950-1:2003 and CSA C22.2
60950-1:2003 standards and found
to be in compliance with the standard
requirements.
RF Exposure Notice
For body worn operation, this product
has been tested and meets RF
exposure guidelines when used with
an accessory that contains no metal.
Use of other accessories may not
ensure compliance with RF exposure
guidelines.
This equipment was tested for RF
Exposure compliance and meets the
requirements with Maximum Peak
Spatial-Average SAR1g of 0.01 W/
kg. No metallic accessories should
be used with this device and multiple
devices should not be co-located at a
distance of less than 20 cm.
Warning: Changes or modifications
not expressly approved by
TANDBERG could void the user’s
authority to operate this equipment.
U8 06 10 61052 001
12
TANDBERG CONTENT SERVER
USER GUIDE
Table of
Contents
What’s New in
this Version?
Trademark/
Licenses
Safety/
Environmental
Introduction Installation Quick Setup Operation
Administrator
Settings
Conference
Setup
View
Conferences
Appendices
D 13898.04
DECEMBER 2006