TANDBERG Codec C90 D14129.02 - Manual (Page 35)

D14129.02—NOVEMBER 2008 35
Codec C90 Administrator Guide
Contents Introduction Getting started About the menus About the settings Settings Library Cameras Appendices Contact us Cameras
Power supply connection
is NOT needed when the
camera is used with a
TANDBERG Codec.
Connecting HDMI HD Video out on camera to HDMI 1 In on the Codec.
If you need to connect the camera to a TANDBERG Video Switch or to a system with a DVI-D socket, use
the enclosed HDMI to DVI-D adapter.
HD-SDI socket
HDMI and HD-SDI
can be used simultaneously.
VISCA™ is a trademark of Sony Corporation
Connecting the camera
The HDMI and HD-SDI can be used
simultaneously.
HDMI cable
The HDMI cable delivered with the camera is
5 meters.
Maximum length is 15 meter with a category 2
certified good quality HDMI cable.
HD-SDI cable
The HD-SDI cable must be purchased
separately. The maximum recommendable
length of HD SDI cable is 100 m.
HDMI to DVI-D adapter
The HDMI to DVI-D adapter is used when
connecting to a TANDBERG MXP codec or
TANDBERG Video Switch
Connect the camera control cable, RJ45 to RS-232 .
Visca™ protocol is supported.