Safety, Important safety instructions, Read and save these instructions – Thermador WD30 EU User Manual
Page 3: Appliance handling safety, Safety codes and standards, Electric safety
English 1
Safety
WARNING:
If the information in this manual is not followed exactly, fire or shock may result
causing property damage or personal injury.
WARNING:
Do not repair or replace any part of the appliance unless specifically recommended
in the manuals. Improper installation, service or maintenance can cause injury or
property damage. Refer to this manual for guidance. All other servicing should be
done by a qualified technician.
Appliance Handling Safety
Hidden surfaces may have sharp edges. Use caution when reaching behind or
under appliance.
Safety Codes and Standards
This appliance complies with one or more of the following Standards:
•
UL 858, The Standard for the Safety of Household Electric Ranges
•
UL 923, The Standard for the Safety of Microwave Cooking Appliances
•
UL 507, The Standard for the Safety of Electric Fans
•
ANSI Z21.1, The American National Standard for Household Cooking Gas
Appliances
•
CAN/CSA-C22.2 No. 113-M1984 Fans and Ventilators
•
CAN/CSA-C22.2 No. 61-M89 Household Cooking Ranges
It is the responsibility of the owner and the installer to determine if additional
requirements and/or standards apply to specific installations.
Electric Safety
Before you plug in the electrical cord, be sure all controls are in the OFF position.
For appliances equipped with a cord and plug, do not cut or remove the ground
prong. It must be plugged into a matching grounding type receptacle to avoid
electrical shock. If there is any doubt as to whether the wall receptacle is properly
grounded, the customer should have it checked by a qualified electrician.
If required by the National Electrical Code (or Canadian Electrical Code), this
appliance must be installed on a separate branch circuit.
Installer - show the owner the location of the circuit breaker or fuse. Mark it for easy
reference.
Important - Save these instructions for the local electrical inspector's use.
Before installing, turn power OFF at the service panel. Lock service panel to prevent
power from being turned ON accidentally.
Refer to data plate for more information. See "Data Plate" under "Service" for data
plate location.
Important Safety Instructions
READ AND SAVE THESE INSTRUCTIONS