Toshiba Strata DK 16 User Manual

Page 12

Advertising
background image

PROGRAMMING PROCEDURES-INTRODUCTION
SECTION 100-816-301
MARCH 1993

1-8

Initialize Programs 00 ~ 97 every time:

• Installing a new system
• To bring a system's programming back to the default setting.

Specify the range as follows:

To initialize one program at a time, enter just the individual program number, then

#

.

3.36 Initialize Speed Dial Numbers, Voice Mail
Identification Codes, Character Message
Memory, Timed Reminders, Digital Telephone
Volume, and Call Forward Backup Memory with
Program 92
. Complete this step if the system is
being installed for the first time, or when all currently
programmed Speed Dial numbers or the like must
be deleted. Follow the steps in Table 1-D and refer
to Figure 1-4.

4 AFTER INITIALIZATION

4.01 Immediately after initializing the system, Pro-
gram 03
must be run to inform the software of the
system hardware configuration (Table 1-E), Pro-
gram 00
to assign remote maintenance security
codes and to check the system software level
(Table 1-F), and Program 04 to assign station
numbers (Table 1-G). Anytime after initialization,
the time and date can be set. Refer to Figures 1-5,

1-6, and 1-7 on instructions on how to set the time
and date.

NOTE:
It is not necessary to run Program 03 for the
STRATA DK8.

4.02 Enter data from the record sheets. For help in
entering program data from the record sheets, see
Tables 1-A and 1-B. The data entry methods used
in these tables reflect the entry methods used for
most of the programs.

5 TELEPHONE BUTTON LABELS

5.01 This programming section makes references
to specific telephone buttons. Depending on the
telephone, the label designations for these buttons
vary. The labels referred to in this section appear on
the 2000-series Digital Telephones; see Table 1-H
for the labels of other telephone models.

*

0

0

9

7

FIGURE 1-3
INITIALIZING DATA FOR PROGRAMS 00 ~ 97 WITH PROGRAM 90

H

Z

Z

9

P

S

H

S

0

Enter programming mode

END Program 90

Button 1 and 2 LEDs must be lit

Program(s) to be initialized

EXIT programming mode

01

02

or

Advertising