Remote control of the k1 av – T+A Elektroakustik K1 AV User Manual
Page 8
Remote control of the K1 AV
The F6 remote control
handset controls all the
functions of the K1 AV. The
adjustments you make are
displayed on the machine’s
integral screen and also on
any TV set which is
connected to the system.
ON
This button switches the K1 AV on and off.
• If the system is being operated in single-room mode, the
loudspeaker outputs
A and B are always at the setting
which was last used when the machine is switched on.
• If the system is set to multi-room mode, only the speakers in
the operator’s room are switched on; the other pair of
loudspeakers are muted.
Volume control
Rocker switches for volume control: a brief press changes the volume
by one increment. If the rocker is held in one position, the volume
changes continuously until it is released again. The screen briefly
displays the current volume value.
Loudspeaker outputs
This button toggles the loudspeaker outputs on and off. The speaker
groups are switched OFF in the following sequence: A (main room), B
(adjacent room), A + B (main and adjacent rooms), OFF. The
corresponding symbols light up on the K1 AV’s integral screen to
indicate the current operating mode.
A long press on the
button switches all the
loudspeaker groups off directly (Mute setting).
Selecting the listening source
Pressing a source button selects the corresponding device as the
listening source, even if the K1 AV was previously switched off. The
signal from this source is then reproduced by the system.
It is only possible to remotely control the device which is currently
selected as the listening source.
Selects the integral disc player.
Selects the integral tuner.
Selects the AUX input.
Selects the TAPE input (recording device).
Selects the TV set connected to the Scart socket.
When you switch to a new listening source, the screen briefly
displays the new source. After this it reverts to a standard
machine-specific display.
Playback mode
Cycles through the playback modes when the button is repeatedly
pressed.
STEREO Stereo playback via the left and right loudspeakers
MUSIC
Three-channel music playback (left, right, centre)
MOVIE
Three-channel film reproduction (left, right, centre)
It is only possible to set the playback mode if a Centre
loudspeaker is present in the system, and if it has been
activated in the 'Amplifier Setup menu / Centre
loudspeaker').
brief press:
Amplifier
long press:
Amplifier Setup menu
8